Every user of an inflatable boat should know how to assemble and disassemble his floating craft. In order to make it correctly you should follow the below instructions.
Inflatable boats should be assembled on a flat surface. It is not recommended to make it on the sand because of the risk that the sand particles can get into the valves. During the first inflation you should remove caps from the valves and make sure that the bleeding button is in the correct position. The bleeding button should be in the upper position. It means that the valve is closed. To begin inflation of a boat the tip of a pump adaptor should be inserted in the valve.
You can inflate a motor boat with the help of an electrical compressor, reducing the time of assembling. The timber flooring should be installed with the rough surface up and the smooth surface down. The board-shaped timber flooring is made of damp-proof plywood sheets, connecting to each other with the help of aluminum fasteners. Start the installation of a floor planking by inserting the appropriate flooring module into the bow area of a boat.
Rubber boats have side stringers ensuring higher rigidity and safety. Seats are the last to be inserted in the special housings in the boat’s tubes. After that you can inflate the boat to the full. It is mandatory to see that the tubes are inflated uniformly. Then it is time to turn to the keel.
The disassemble procedure is described below:
When the boat is completely deflated, put it on the ground with the bottom down, fold the tubes inwards and see that the width of the folded construction does not exceed the width of the transom. The ends of the tubes in the stern area should be folded and pressed to the transom. After that the boat should be folded ib the direction from the transom to the bow and put in a bag for further transportation. Bark.ua offers BARK boats on favorable terms. We have a broad assortment of top quality models at an affordable price, let alone warranty package.